Model |
ISW-1022M |
Hardware Specification |
10/100Mbps Copper Ports |
8 10/ 100Base-TX RJ-45 Auto-MDI/MDI-X ports |
10/100/1000Mbps Copper Ports |
2 10/100/1000Base-T RJ-45 Auto-MDI/MDI-X ports |
SFP / mini-GBIC Slots |
2 1000Base-SX / LX / BX, shared with Port-9~Port-10, compatible with 100Base-FX SFP |
Switch Architecture |
Store-and-Forward |
Switch Fabric |
5.6Gbps / non-blocking |
Switch Throughput |
8.3Mpps |
Address Table |
8K entries |
Share Data Buffer |
1Mbit |
Maximum Frame Size |
1522 Bytes packet |
Flow Control |
Back pressure for half duplex, IEEE 802.3x Pause Frame for full duplex |
LED |
Per unit: Power (Green), Power 1 (Green), Power 2 (Green), Fault (Red) 8 port 10/100: Link/Activity (Green), Full duplex/Collision (Yellow) SFP port: LNK/ACT(Green), 1000T: LNK/ACT(Green), 1000M(Green)
|
Console Interface |
One RJ-45-to –RS-232 male connector for switch management |
Power Input |
12 to 48V DC, Redundant power with polarity reverse protection function |
Power Consumption |
8.16Watts max. |
Operating environment |
-10 ~ 60 Degree C |
Storage environment |
-40 ~ 85 Degree C |
Dimension ( W x D x H) |
72 x 105 x 152 mm |
Weight |
948g |
Layer 2 Function |
Redundant Ring |
5 ports for Redundant ring to provide redundant backup feature and the recovery time below 20ms. It supports ring modes as below: • Standard Ring • Couple Ring • Dual Homing |
Port Configuration |
Port disable/enable Auto-negotiation 10/100Mbps full and half duplex mode selection. Flow Control disable / enable. Bandwidth control on each port.
|
Port Status |
Display each port’s speed duplex mode, link status, Flow control status. Auto negotiation status |
VLAN |
Port-Based VLAN, up to 9 VLAN groups IEEE 802.1q Tagged Based VLAN , 4K VLAN ID, up to 256 VLAN groups
|
Spanning Tree |
IEEE 802.1d Spanning Tree IEEE 802.1w Rapid Spanning Tree
|
Link Aggregation |
Supports 4 groups of 4-Port trunk support |
QoS |
Traffic classification based on : • Port Number • 802.1p priority • IP DSCP/TOS field in IP Packet
|
IGMP Snooping |
v1 and v2 256 multicast groups and IGMP query
|
Bandwidth Control |
Per port bandwidth control • Port-1~Port-8 rate range: 100 kbps to 102400 kbps • Port-9~Port-10 rate range: 100 kbps to 256000 kbps Storm control • Broadcast / Multicast / Unknown Unicast packet
|
Port Mirror |
RX / TX / Both |
Security |
Port Security • Support 100 entries of MAC address for static MAC and another 100 for MAC filter
|
Management |
Management Interface |
Console, Telnet, Web Browser, SNMP v1, v2c and v3 |
Management IP Security |
Support 10 IP addresses that have permission to access the switch management and to prevent unauthorized intruder |
System Event Log |
System Event Log • System Log Server/Client • SMTP E-mail Alert • Relay Alarm Output System Events
|
Alarm |
Provides one relay output for port breakdown, power fail and link down port. Alarm Relay current carry ability: 1A @ DC 24V
|
SNMP MIBs |
RFC-1213 MIB-II RFC 1157 SNMP MIB RFC-2863 Interface MIB RFC-1493 Bridge MIB RFC-2674 Extended Bridge MIB (Q-Bridge) RFC 1643, RFC 1757, RSTP MIB Private MIB
|
Standards Conformance |
Regulation Compliance |
FCC Part 15 Class A, CE |
Standards Compliance |
IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX / 100BASE-FX IEEE 802.3z Gigabit SX/LX IEEE 802.3ab Gigabit 1000T IEEE 802.3x Flow Control and Back pressure IEEE 802.1d Spanning tree protocol IEEE 802.1w Rapid spanning tree protocol IEEE 802.1p Class of service IEEE 802.1Q VLAN Tagging IEEE 802.1x Port Authentication Network Control
|
Stability |
IEC60068-2-32 (Free fall) IEC60068-2-27 (Shock) IEC60068-2-6 (Vibration)
|